Monday, October 25, 2010

Repair parts for Casablanca Inteli-Touch 3 system, W-85

Casablanca W-85 www.FanManLighting.com
| Fan Man Lighting | Authorized Casablanca Parts & Service |

Casablanca's Inteli-Touch 3 system uses the W-85 wall control. W-85 wall controls will operate both single circuit and 3-way wiring situations.

The W-85 is the replacement part for all W-11, W-12, W-32, and W-31 Inteli-Touch wall controls. To convert to the new system, you will also need a new circuit board and conversion plug (*note the BFR is not used with IT3). Fan Man Lighting has created conversion kits for each series of Inteli-Touch ceiling fan. Inteli-Touch Diagnostic/Troubleshooting.



Questions? Call us with your model and serial number 952-898-2754 or 952-683-9450

Protect your ceiling fan controls from excessive transient voltages with a Varistor.


These items and more available online www.FanManLighting.com

10 comments:

  1. Please post any questions or comments you might have about this Blog.
    Visit our main website to view a selection of our products. www.fanmanlighting.com


    ~ The Fan Man
    952-898-2754 or 1-866-600-FANS(3267)

    Fan Man Lighting
    14250 Burnhaven Dr
    Burnsville,MN 55306

    ReplyDelete
  2. My RMM V had a Varistor but the circuit board still went bad. What exactly does the Varistor protect again (what is excessive transient voltage). Do I need I need to put the Varistor in myself or will it be shipped with it?

    Thanks!
    Ziyadah

    ReplyDelete
    Replies
    1. Hello Ziyadah,

      The surge protector will protect against voltage spikes or surges. Changing a light bulb with power on, or a light bub burning out, may affect the circuit board even with a surge protector wired in.

      Surge protectors are sold as an add-on component for older model fans.

      Call us with any questions.

      The Fan Man
      952-898-2754 or 1-866-600-FANS(3267)
      www.fanmanlighting.com

      Delete
  3. That is a sign of substandard design. Had 3 of these so-called controllers blow up. No excuse for this in 21st century. And yes, I am an electrical engineer and yes I design electronic systems.

    ReplyDelete
  4. after installing a w-84 according to directions the unit worked, but then began to smoke when I was changing fan speeds and dimmer control. I promptly turned off the breaker. I checked all my connections.
    The only thing I can think is that the two black leads were switched. The "in from ac power was to go to the black lead with a white stripe.Help...

    ReplyDelete
  5. Thanks you very much for sharing these links. Will definitely check this out.. ac repair services

    ReplyDelete
  6. My fan will only run on high. I can hear it time but runs on high or off.
    I am able to reverse the direction.
    Model# C5S65T

    ReplyDelete
  7. I would guess the circuit board is out. So the surrender protector and new board it's most likely what I need.
    Please contact me so I can repair it.

    ReplyDelete
  8. Fascinating post. I Have Been pondering about this issue, so a debt of gratitude is in order for posting. Really cool post.It 's truly extremely pleasant and Useful post.Thanks hvac repair services ludowiciga

    ReplyDelete
  9. you would think in this day and age a reasonable priced conversion would be produced and work as good or better than casablanca original intelli-touch units. I have six of them and keeping up with these versions is a night mare and very expensive!

    ReplyDelete