Monday, June 28, 2010

Ceiling Fan Troubleshooting / Diagnostic

Ceiling Fans | Home Lighting | Water Features | Casablanca Repair Parts | UC7067 Remote Receivers |

www.fanmanlighting.com

Many problems associated with Ceiling Fans can be attributed to the installation, and are easily corrected. Below is a general overview of the more common things missed, or done improperly when installing a Ceiling Fan. If you have more specific questions about the operation of any ceiling fan. Please contact us 952-898-2754 or 1-866-60-FANS(3267). With over 20 years of experience in Ceiling Fans and Home Lighting. "Our knowledge is Free!"

Other helpful information: Ceiling Fan Facts, Casablanca Intelli Touch Diagnostic, Casablanca Flywheel Repair, UC7067RC universal remote receiver.



Noise

Motor size is the key to quality. Over time, it is not uncommon for smaller motors to develop sounds that are unrepairable. Below are a few tips that may help determine if that is the case.
Switching: The use of a dimmer or rheostat wall control on the motor will cause any ceiling fan to "Hum". Ceiling Fan motors need to be run from a switch that has set speeds. SW95 or SW90 are switches that will work with most brands.
Mounting: Anything not tightened properly may result in amplifying any sounds the ceiling fan might make. Make sure all screws and light fixture glass are tight. Electrical box, down rod set screws, blade assemblies etc.


Wobble
It is considered "Normal" to have a small bit of motion in any Ceiling Fan running on high speed. Blade balancing kits included with most ceiling fans, can reduce or eliminate this type of motion. Below are a few tips if the ceiling fan wobbles excessively. The easiest test for loose or poor mounting; Give the bottom of the ceiling fan a light push with your finger. On stem mount fans it should come back to center and stop. If the fan keeps moving, follow these tips for excessive motion.
Mounting: The electrical box in the ceiling needs to be metal, and securely mounted to a joist or brace kit. The mounting bracket from the ceiling fan must be tight to the electrical box.
Down rod or Stem: On ceiling fans with a down rod or stem. Make sure the groove on the ball at the top of the stem is aligned with the notch on the mounting bracket. There are usually multiple set screws to tighten at the ball and where the stem mounts into the top of the ceiling fan.
Blades: Ceiling Fan blades are matched sets, weighted within a gram of each other. Loose or warped blades can be a cause of wobble. Make sure all screws holding the blades to the irons, and the blade assembly to the motor a tightened properly. To determine if you have a warped blade or bent blade iron: Use a ruler to measure from the tip of the blade to the ceiling. Let the blades pass by the ruler to see if one or more is higher or lower than the rest. There can be a slight difference in height that will not cause any wobble issues.

Operation
Ceiling Fans that stop working, or fail to operate when first installed may need check a few basic things first.
Wiring: Make sure there is power to the ceiling fan and the wall switch is in the "On" position. Follow the wiring instructions included with the fan and double check connections.
Switch housing: The switch housing is the bottom portion of the ceiling fan where the light is attached. Move reverse switch to one side or the other (stuck in the middle makes fan inoperable). Make sure any plug connections are properly inserted. Check either side of plug connections for any wires that are loose or pushed out of the plug.
Wall Switch: When using a wall switch make sure the pull chain on the motor is set to the highest speed.
Smell or Odor: Ceiling fans that give off a bad smell, typically need a new capacitor. Call us for identification
Remote systems: Make sure the receiver and transmitter are set to the same frequency, and wired according to the instructions. For receiver replacement, most ceiling fans use a receiver with the model number UC7067RC.

The above is a general overview of the more common things missed, or done improperly when installing a Ceiling Fan. If you have more specific questions about the operation of any ceiling fan. Please contact us 952-898-2754 or 1-866-600-FANS(3267). Visit our main website www.fanmanlighting.com

Ceiling Fans | Home Lighting | Home Staging  | Casablanca Repair Parts | UC7067RC

3 comments:

  1. Please post any questions you might have on this Blog.
    Visit our main website to view a selection of our products. www.fanmanlighting.com


    ~ The Fan Man
    952-898-2754 or 1-866-600-FANS(3267)

    Fan Man Lighting
    14250 Burnhaven Dr
    Burnsville,MN 55306

    ReplyDelete
  2. Fan Man... I have several older Casablancas originally purchased between 1991 and 1996 or so. All of the fans are in good condition, still work perfectly, and quietly. However, some of the controllers do not work so well - sporadically changing speeds or direction when trying to turn the fan on or off. The original controllers are W-11 models. A local dealer sold me a W-85 that doesn't seem to work with these models. Is there a model that will work with these without converting / upgrading the fan itself? What is the W-35 model - would that work?

    ReplyDelete
  3. Nice post. I was checking constantly this blog and I am impressed! Extremely helpful information specially the last part I care for such info a lot. I was seeking this particular information for a very long time. Thank you and good luck. https://bowerylightingco.com

    ReplyDelete